|
[EDI-L Mailing List Archive Home]
[Message List]
[Reply To This Message]
RE: Setting up TRADAOMS partners on GEIS EDI EXPRESS
Hi all,
Just a quick note:
SNDR ID/QLFR incorrect error message from EDI*EXPRESS.
If you setup your "ANY" Trading Relationship with your partner, then this
error will come up if your partner has not yet approved your request for the
trading relationship and you have attempted to send them data that was
otherwise valid. Run a Trading Relationship report and it will show you the
status of the relationship. If it shows "Pending", then your partner needs
to approve your request before trading may begin. It should show "Active"
meaning it's been approved. Before trading can begin, one party must create
the relationship request and the other must approve it before data will
flow. Your email suggests you created the request but your partner may not
have approved it yet. If your partner uses an Interconnect with GXS, then
it "should" be automatically approved - the TPR report will show you it's
status and then please allow 3 hours for it to replicate over the "many"
machines used to run the service (IE: after your partner appoves it, give it
a few hours before attempting to use it - I have timed this and it generally
takes 1.5 hours to replicate over all the nodes databases, but I'm in
Australia so my daytime is the U.S. night-time so during the U.S. day it may
be slower).
Tradacoms does not require EDI Address Qualifiers, they are optional.
EDI*EXPRESS will support Tradacoms with or without Address qualifiers.
Cheers...
Michael Burbury
GE ecXpress Australia
Systems Administration
-----Original Message-----
From: Uppaji Kothapalli [mailto:
Sent: Tuesday, October 08, 2002 2:34 PM
To:
Subject: [EDI-L] Setting up TRADAOMS partners on GEIS EDI EXPRESS
Hi All, thanks for your inputs on the EDIFACT issue.
FInally CLEO has to update their VARFILE for the CR+LF
as requird by GEIS.
Now I have one more question:
Has any one got the experience of settting up of the
TRADACOMS partners on GEGXS EDI Express website? What
should be used for the "format type" :
ANY/STX*ANA*1/STX*ANAA*1.......
please suggest.
Also do we have to include the qualifiers? As the
documents come with NO qualifiers.
The documents are failing with the errror" SNDR
ID/QLFR incorrect" inspite of setting up of the FORMAT
to ANY.
Any help/suggestion would be greatly appreciated.
Best Regards
Uppaji.
|
|
Subscribe in XML format
| RSS 2.0 |
|
| Atom 0.3 |
|
|
Cart
